TM 5-3805-248-23-1
RADIATOR ASSEMBLY, SUPPORT ASSEMBLY AND MOUNTING MAINTENANCE - CONTINUED
0044 00
RELIEF VALVE INSTALLATION
NOTE
Align holes during installation in the following steps.
1.
Install new gasket (7), plate (6) and new gasket (5) at top of radiator.
2.
Install valve assembly (4) and cover (3).
3.
Install five washers (2) and bolts (1).
4.
Inspect coolant level in radiator and add as required (WP 0042 00).
RADIATOR ASSEMBLY, SUPPORT ASSEMBLY AND MOUNTING REMOVAL
WARNING
DO NOT remove cooling system radiator cap when engine is hot. Allow engine to cool down. Loosen cap to
first stop and let any pressure out of cooling system, then remove cap. Failure to follow this warning may cause
serious burns.
Wear effective eye, glove and skin protection when handling coolants. Failure to do so may cause injury.
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may result in death or injury to personnel.
CAUTION
Wipe area clean around all connections to be opened during removal and disassembly. Cap lines and plug
openings after removing lines. Contamination of cooling system could result in premature failure.
NOTE
Tag lines prior to removal to ensure correct installation.
Use a container to capture draining coolant. Dispose of coolant IAW local policy and ordinances.
Ensure all spills are cleaned up.
0044 00-3
