TM 5-3805-248-23-1
FINAL DRIVE MAINTENANCE - CONTINUED
0143 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may cause
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
1.
Clean all parts with solvent cleaning compound.
2.
Dry with compressed air.
3.
Inspect all parts for damage and replace damaged parts as necessary.
CAUTION
Install all components as marked to prevent damage to equipment.
ASSEMBLY
1.
Install six studs (18) on carrier (8) and torque to 40 lb-ft (54 Nm).
2.
Install three spacers (12), bearings (14) and bearings (11).
3.
Install three spacers (15) and spacers (10) in gears (13).
4.
Install three gears (13) in carrier (8).
5.
Install three shafts (16) with flat end toward outside.
6.
Install three rings (17).
0143 00-4
