TM 5-3805-248-23-1
APRON CYLINDER REPLACEMENT - CONTINUED
0244 00
REMOVAL - CONTINUED
1.
Attach lifting device to apron cylinder assembly at rod end, below flange.
2.
Remove two bolts (2), washers (3) and plate (1).
3.
Remove pin (4) and two bearings (5).
2,3
4,5
1
394-567
4.
Operate engine (TM 5-3805-248-10).
5.
Retract rod of apron cylinder assembly (TM 5-3805-248-10).
WARNING
Do not remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2,500 psi
(17,237 kPa), even with engine and pump off. To relieve pressure, lower all hydraulic attachments to the
ground and shut down engine. Move control levers through all operating positions, then slowly loosen
hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping
hydraulic fluid under pressure can penetrate skin, causing injury or death.
Hydraulic oil is very slippery. Immediately wipe up any spills. Failure to follow this warning may cause
injury.
6.
Shut down engine (TM 5-3805-248-10).
7.
Move hydraulic control levers back and forth. Release all hydraulic oil pressure.
8.
Loosen hydraulic tank filler cap (WP 0231 00).
9.
Disconnect apron cylinder hose assemblies (WP 0237 00).
0244 00-2
