TM 5-3805-248-23-2
CYLINDER HEAD ASSEMBLY MAINTENANCE - CONTINUED
0259 00
REMOVAL - CONTINUED
4.
Remove 12 bolts (9) from top left of cylinder head assembly.
5.
Remove 20 bolts (7) and washers (8) from top of cylinder head assembly.
7
CYLINDER
HEAD
ASSEMBLY
9
8
394-609
CYLINDER
REAR EXHAUST
PORT
BLOCK
PORT
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Weight of cylinder head assembly is 300 lb (136 kg).
6.
Install lifting device to cylinder head assembly.
CAUTION
Do not scratch or distort machined surfaces of cylinder head assembly.
7.
Separate cylinder head assembly from cylinder block. Use a prybar to insert into front and rear exhaust ports located on
right of cylinder head assembly. Lift upwards just enough to separate cylinder head assembly from cylinder block.
8.
Use lifting device to remove cylinder head assembly.
0259 00-3