TM 5-3805-248-23-2
HYDRAULIC RETARDER MAINTENANCE - CONTINUED
0289 00
ASSEMBLY - CONTINUED
22.
Install four washers (48) and bolts (49) through rear of stator (47) assembly.
23.
Position deflector (51) and gear (50) assembly on four bolts (49) on front face of stator (47). Align four bolts (49) and
tighten bolts to 36 lb-ft (49 Nm).
NOTE
50
Ensure gear turns freely in stator and that
ends of rings installed on carriers are prop-
51
erly engaged before assembling stator and
rotor assemblies.
47
48
49
394-738
24.
Position stator (47) assembly on housing (12) assem-
bly and install 12 bolts (46). Torque 12 bolts to 36 lb-ft
(49 Nm).
46
47
12
394-739
25.
Install cover (28) in soft-jawed vise, with front of cover facing up.
26.
Use driver group and hammer to install new seal (45), with lip side down and the opposite face of seal flush with point
A of cover (28).
27.
Use clean lubricating oil to lubricate seal (45) lip.
41
28.
Install bearing (41) until it is seated at point B.
B
A
28
45
394-740
0289 00-15
