TM 5-3805-248-23-2
SUPPLEMENTAL STEERING PUMP REPLACEMENT - CONTINUED
0307 00
REMOVAL - CONTINUED
CAUTION
Removal of bearing from rear cap of differential housing will cause destruction of bearing. Remove bearing
only if inspection indicates replacement is necessary.
22.
Use a hammer and chisel to remove and discard bear-
ing (35), if necessary.
DIFFERENTIAL
HOUSING
394-924
35
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may cause
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Remove all preformed packing material from mounting surfaces.
2.
Clean all parts with solvent.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
0307 00-7
