TM 5-3805-248-23-2
HYDRAULIC STEERING SERVO-RECEIVER CYLINDER REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Materials/Parts - Continued
Maintenance Level
Packing, preformed (4)
Direct Support
Pin, cotter (2)
Tools and Special Tools
References
Tool kit, general mechanic's (Item 113, WP 0338
WP 0202 00
Materials/Parts
Equipment Condition
Cap set, protective (Item 6, WP 0339 00)
Hydraulic tank drained (WP 0229 00)
Oil, lubricating (Item 32, WP 0339 00)
Retarder oil cooler assembly removed (WP 0291
Rag, wiping (Item 35, WP 0339 00)
Hood removed (WP 0189 00)
Tag, marker (Item 42, WP 0339 00)
REMOVAL
WARNING
Do not remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2,500 psi
(17,237 kPa), even with engine and pump off. To relieve pressure, lower all hydraulic attachments to
the ground and shut down engine. Move control levers through all operating positions, then slowly
loosen hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure.
Escaping hydraulic fluid under pressure can penetrate skin, causing injury or death.
Hydraulic oil is very slippery. Immediately wipe up any spills. Failure to follow this warning may
cause injury.
