TM 5-3805-248-23-2
SCRAPER CONTROL VALVE REPLACEMENT - CONTINUED
0323 00
INSTALLATION - CONTINUED
5.
Connect hose and tube assemblies (WP 0232 00).
6.
Refill hydraulic oil tank (TM 5-3805-248-10).
7.
Inspect hydraulic oil lines and connections for leaks or damage.
TESTING AND ADJUSTMENT
Sequence Valve
WARNING
Only qualified personnel may perform the following procedure. All other personnel must clear the immedi-
ate area of the machine. Failure to follow this procedure may cause injury.
1.
Remove plug (5).
5
2.
Install adapter (6).
3.
Install hose (7) and gage (8).
4.
Start engine and run at high idle (TM 5-3805-248-10).
5.
Move apron control lever to raised position and hold.
8
Observe gage. High reading on gage is pressure set-
ting of relief valve. Correct reading is 2,00050 psi
(13,790345 kPa). If reading is NOT in these limits,
proceed to next steps.
6.
Stop engine.
7
6
0323 00-3
