TM 5-3805-248-23-2
PISTON AND CONNECTING ROD MAINTENANCE - CONTINUED
0348 00
REMOVAL - CONTINUED
1.
Install 14-3/4 x 3NF bolts and 28-3/4 in. copper wash-
BOLTS AND
ers in block to secure top plate and six cylinder liners.
COPPER WASHERS
Use two washers for each bolt. Torque 14-3/4 x 3NF
bolts to 15 lb-ft (20 Nm), then once again to 40 lb-ft.
(54 Nm).
394-1156
NOTE
Repeat steps 2 through 6 for removal of remaining piston and connecting rod sets. Keep all sets separated
and tag for identification.
2.
From front of cylinder block, rotate crankshaft counterclockwise until two connecting rods are at bottom dead center.
NOTE
Inspect two connecting rods and cap for identifying mark. If no mark is present, scribe or stamp numbers to
ensure proper installation in original location.
3.
Remove two nuts (1) and cap (3) assembly from con-
necting rod (2) journal.
2
1
3
394-1157
0348 00-2
