TM 5-3805-248-23-2
CRANKSHAFT MAIN BEARINGS MAINTENANCE - CONTINUED
0347 00
END BEARINGS INSTALLATION
1.
Use clean engine oil to lubricate four washers (13), bolts (14) and two bearings (11).
2.
Position two bearing cap (12) assemblies under corresponding crankshaft journals and align holes in two bearing caps
(12) with holes in cylinder block.
3.
Install and hand-tighten four washers (13) and bolts (14).
4.
Torque two bolts (14) at bearing tab side of bearing caps (12) to 190 lb-ft (258 Nm).
5.
Torque two bolts (14) opposite bearing tab side of bearing caps (12) to 190 lb-ft (258 Nm).
6.
Use chalk to mark four bolts (14) and two bearing caps (12).
7.
Tighten two bolts (14) opposite tab side of bearing caps (12) 120 degrees.
8.
Tighten two bolts (14) at bearing tab side of bearing caps (12) 120 degrees.
11,12
13
14
TAB SIDE
BOLT HEAD
MARK BOLT
HEAD AND
BEARING CAP
120 DEGREES
394-1155
OPPOSITE TAB SIDE
9.
Install oil pump (WP 0267 00).
10.
Operate engine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0347 00-14
