TM 5-3805-248-23-2
STARTING MOTOR (DELCO-REMY) REPAIR - CONTINUED
0361 00
ASSEMBLY
1.
Position insulator (70) by wrapping around field coil (19), if removed.
2.
Position the sides of four shoes (76) with long lip being assembled in field coil (19), in the direction of armature rotation
so it becomes the trailing (not leading) edge of four shoes (76).
3.
Install field coil (19) in housing (13). Do not tear insulator (70). Support field coil (19) with hand or pole shoe spreader.
NOTE
Careful installation of the field coil is necessary to prevent shorting or grounding of the field coil as shoes
are tightened into place.
4.
Install bushing (71) on stud of wire assembly on field coil (19). Position wire through port of housing (13). Position wire
around inner circumference of housing (13) and hold in place by bending back three tabs.
5.
Install eight screws (75) through housing (13), securing field coil (19) with four shoes (76). Tighten eight screws (75)
evenly.
6.
Install two washers (72), washer (73) and nut (74).
74
73
72
70
71
75
13
19
76
394-1380
0361 00-8
