TM 5-3805-248-23-2
PRESSURE AND SELECTOR VALVE ASSEMBLY REPLACEMENT - CONTINUED
0364 00
INSTALLATION - CONTINUED
71.
Position cam assembly in transmission case over gov-
52
ernor cutoff valve assembly (86). Spacer (69) engages
53
spool link on selector valve assembly (87).
72.
Install four washers (53) and bolts (52). Torque four
CAM ASSEMBLY
bolts to 35 lb-ft (47 Nm).
73.
Inspect selector valve assembly (87) spool (A). Make
sure spool end is flush with face of valve body. If posi-
tion is not correct, complete steps 76 through 78.
86
394-687
NOTE
Steps 76 through 78 are preformed only if inspection indicates selector valve assembly spool is not in proper
position.
74.
Loosen locknut (A) on spool (A).
75.
Rotate spool (A) until end is flush with face of valve body.
76.
Holding spool (A) to prevent it from turning, torque locknut (A) to 15 lb-ft (20 Nm).
LOCKNUT (A)
83
SPOOL (A)
394-812
0364 00-36
