TM 5-3805-248-23-2
PRESSURE AND SELECTOR VALVE ASSEMBLY REPLACEMENT - CONTINUED
0364 00
INSTALLATION - CONTINUED
NOTE
Shaft is in FOURTH speed position when detent is in the sixth notch of cam.
77.
Use locking pliers to rotate shaft (127) until detent
127
SPOOL B
(61) is in FOURTH position (sixth notch) on cam (40).
87
(HIDDEN)
40
61
78.
Inspect selector valve assembly (87) spool (B). Make sure spool (B) end is flush with face of valve body. If position is
not correct, complete steps 81 through 83.
NOTE
Steps 81 through 83 are performed only if inspection indicates selector valve assembly spool is not in proper
position.
79.
Loosen locknut (B) on spool (B).
36
49
80.
Rotate spool (B) until end is flush with face of valve
body.
81.
Holding spool (B) to prevent it from turning, torque
48
locknut (B) to 15 lb-ft (20 Nm).
48
82.
Install new preformed packings (51 and 52) in mani-
49
51
fold (36).
83.
Install two new preformed packings (48) and plugs
(49).
50
394-1756
0364 00-37