TM 5-3805-248-23-2
SUPPLEMENTAL STEERING PUMP REPAIR - CONTINUED
0379 00
ASSEMBLY - CONTINUED
40.
Install two new preformed packings (25) in groove of two new back-up rings (26).
41.
Install two new back-up rings (26) on lip of protruding bearing insert on rear face of flange (6).
42.
Invert flange (6) and use a suitable driver to install new seal (27) in flange (6) with lip side down toward inside of flange
(6). Use clean oil to lubricate bore of new seal (27) and install to a depth of 0.711 in. (18.1 mm).
43.
Install new snap ring (28). Opening in snap ring (28) must be in alignment with oil hole in bore of flange (6).
44.
Use a driver to install new seal (29) in flange (6) with lip side down toward inside of flange (6). Using clean oil, lubri-
cate bore of new seal (29) and install to a depth of 0.154 in. (3.91 mm).
25
26
6
27
28
29
394-1523
45.
Use grease to lubricate front drive gear (33) splines to prevent seals (27 and 29) from being damaged when flange (6) is
installed. Do not turn gears.
46.
Install new preformed packing (22) in groove of flange (6).
47.
Install flange (6) assembly on front body (5), aligning with scribe marks made in step 1 of Disassembly in this work
package.
48.
Install eight washers (23) and nuts (24) loosely on studs (49).
5
49
33
23 24
22
6
27,29
394-1522
0379 00-18
