TM 5-3805-248-23-2
SUPPLEMENTAL STEERING PUMP REPAIR - CONTINUED
0379 00
ASSEMBLY - CONTINUED
49.
Use clean oil to lubricate inner bores of rear body (7).
50.
Install two new preformed packings (16) in groove of two new back-up rings (15).
51.
Install two new back-up rings (15) on lip of protruding bearing inserts inside rear body (7).
52.
Install new center separator (21), two new end separators (19), new sealing strips (18) and isolation plates (17). Rounded
edges on outer radius of isolation plates (17) should face bottom of rear body (7). Two new sealing strips (18) must not
be twisted after installation.
CAUTION
Do not force pressure plate into position. Doing so could cause damage to the plate and pump.
53.
Use clean oil to lubricate and install pressure plate (20). Hold pressure plate (20) as level as possible and carefully slide
into position with the bronze side facing the gear and the notched side facing the outlet side.
7
15 16
17
19
18
20
21
394-1521
0379 00-19
