TM 5-3805-248-23-2
SUPPLEMENTAL STEERING PUMP REPAIR - CONTINUED
0379 00
ASSEMBLY - CONTINUED
CAUTION
Do not drop or let rear idler gear or rear drive gear fall into position. Lower slowly so as not to damage pres-
sure plate.
54.
Use clean oil to lubricate and install rear idler gear (14) and rear drive gear (8) in rear body (7). Install rear drive gear (8)
in pocket which will align with coupling (31) in valve body (4). Turn rear drive gear (8) until one of the gear teeth is in
alignment with dowel in rear body (7). Do not move gears after aligning.
55.
Use clean oil to lubricate and install pressure plate (9). Hold pressure plate (9) as level as possible and carefully slide
into position with the bronze side facing the gear and the notched side facing the outlet side.
56.
Use clean lubricating oil to lubricate and install new center separator (10), two new end separators (13), new sealing
strips (12) and isolation plates (11). Isolation plates (11) have the same edge on either side and can be installed either
way. Two new sealing strips (12) must not be twisted after installation.
8
31
(HIDDEN)
9
10
11
7
14
13
394-1520
12
57.
Install new preformed packing (3) in groove of valve body (4).
1
2
3
4
5
6
8
7
48
394-1519
0379 00-20
