TM 5-3805-248-23-2
SUPPLEMENTAL STEERING PUMP REPAIR - CONTINUED
0379 00
ASSEMBLY - CONTINUED
31.
Install new center separator (44), two new end separators (42), new sealing strips (41) and insolation plates (40).
Rounded edges on outer radius of isolation plates (40) should face bottom of front body (5). Two new sealing strips (41)
must not be twisted after installation.
DOWEL
3
41
40
OUTLET SIDE
5
NOTCH ON
PRESSURE PLATE
39
44
42
CAUTION
Do not force plate into position. Doing so could cause damage to the plate and pump.
32.
Use clean oil to lubricate and install pressure plate (34). Hold pressure plate (34) as level as possible and carefully slide
into position with the bronze side facing the gear and the notched side facing the outlet side.
33.
Use clean oil to lubricate and install front idler gear (39) and front drive gear (33). With inner pocket of front body (5)
facing up and outlet port to the left, position front drive (33) in top slot. Align by turning front drive gear (36) until one
of the valleys between two teeth is in alignment with dowel in front body (5). Do not move gears (33 and 39) after align-
ment.
34.
Use clean oil to lubricate and install pressure plate (34). Hold pressure plate (34) as level as possible and carefully slide
into position with the bronze side facing the gear and the notched side facing the outlet side.
0379 00-16
