TM 5-3805-260-10When Required1.Support the cutting edge to be removed. Removethe mounting bolts.Router BitsWith two edges to each bit, double wear can be obtainedby rotating the bits 180°.Cutting Edge TeethTo prevent personal injury to eyes, wear protectiveglasses when striking pins.A pin, when struck, can fly out and cause personalinjury.Change the teeth before the adapters become worn.2.Remove the edge.3.Clean all mounting surfaces.4.Change or rotate the cutting edge.5.Install the cutting edge and all of the mounting bolts.6.Remove the support. See Bolt Torques for GroundEngaging Tools, (page 2-9) torque the bolts.1.Remove the three mounting bolts and the router bit.2.Clean the mounting surfaces.3.Rotate or change the router bit.4.Install the bit and the mounting bolts.5.Torque the bolts. See Bolt Torques for GroundEngaging Tools, (page 2-9).1.Drive the pin out of the tooth through the sideopposite the washer.2-61WARNING
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business