Elevator Chain

TM-5-3805-260-10 Scraper Tractor: Elevating Self-Propelled 11 Cubic Yard Sectionalized and Nonsectionalized Manual
Page Navigation
120

TM 5-3805-260-10 2. Clean the shank, pin and washer. The tooth may be rotated 180° for more or less penetration, as required. 3. Install the washer in the groove. Install the tooth. 4. Install the pin from the side of the tooth opposite the washer. Center the pin in the tooth. 50 Elevator Chain Maintain 7 to 10 in. (18 to 25 cm) between the chain and the frame. Measure midway between the upper and lower rollers. Also, adjust the chain if the sag differs more than 2 in. (5 cm) from one side to the other. If a chain must be taken up more than 3 in. (8 cm), use an offset link to replace 2 links. If it must be let out more than 3 in. (8 cm), insert an off set link between two links. Use offset links in pairs, one on each chain, between the same two elevator flights. 2-62

Privacy Statement
Press Release
Contact