TM 5-3805-260-1049Cutting Edges And Router BitsSupport the cutting edges before removing themounting bolts.CAUTIONDo not attempt to increase wear life by welding oncutting edges. This could result in prematurefailures.Change or rotate the cutting edges or router bits beforethe mounting surfaces become wornBlock the bowl when working in the bowl area.Cutting EdgesWith two edges to each section, double wear can beobtained by rotating them 180º.By exchanging sides, the two end sections can be usedfour times.For finish work align the cutting edges. Move both endsections forward and use the rear mounting bolt holes.For the best penetration when digging, mount the endsections through the front mounting holes. The centeredge is always in the same location. Both rows of boltsshould be used in the center edge in all cases.2-60WARNINGWARNING
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business