TM 5-3805-260-24
OIL FILTER BASE AND ENGINE OIL COOLER
REMOVE OIL FILTER BASE AND
ENGINE OIL COOLER
Tools Needed
A
2P8250
Strap Wrench
1
start by:
a)
remove crankcase guard
NOTE: The radiator is removed for better photo illustration of the
removal and installation of the oil filter base and engine oil cooler.
1. Drain the coolant from the cooling system.
2. Disconnect hoses (I) from the cylinder block.
3. Remove oil filters (3) from the filter base with tool (A).
4. Disconnect oil pressure line (2) from the filter base.
5. Remove four bolts (5) and the washers to remove oil filter
base and engine oil cooler (4) as a unit.
INSTALL OIL FILTER BASE AND
ENGINE OIL COOLER
1. Inspect the O-ring seals in the oil filter base. Install new seals if
needed. Put oil on the seals.
2. Put oil filter base and engine oil cooler (1) in position on the
engine. Install bolts (3) and the washers that hold it in place.
3. Install two oil filters (4) and connect oil pressure line (2) to the
oil filter base.
4. Connect hoses (5) and (6) to the cylinder block.
5. Fill the cooling system with coolant to the correct level.
6. Start and run the engine. Make a check of the engine oil level and
add engine oil to the correct level
end by:
a) install crankcase guard
3-53
