TM 5-3805-260-24
4. If removed, install the bushing and lip-type seal, with
tooling (B), into the shift lever housing Install the O-
ring seals on the outside of the housing
5. Put washer (25) and shift lever housing (19) in
position over the armature shaft Make sure to align
the
marks
on
the
housings
made
during
disassembly.
6. Install the five bolts and tighten them to a torque of 16
3 to 22 0 N-m (12 to 16 lb ft ). Install the brake disc
on the armature shaft
7. Put pinion drive assembly (17) and shift lever
assembly (26) Into position on the armature
shaft and Into the shift lever housing
8. Install the O-ring seals on the shift lever pin if
they were removed Install the pin through
the shift lever housing and shift lever Install
retainer with tool (A)
9. Put plunger assembly (27) into the shift lever Install
the nut finger tight right now. The plunger assembly
will have to be adjusted for the correct pinion
clearance
after
the
starting
motor
has
been
completely assembled
10. If removed, install the bushing into pinion
drive housing (13) with tooling (B). Install
the outside O-ring seal
11. Put the pinion drive housing assembly into
position on the shift lever housing Make
sure to align the marks on the housings
made during disassembly Install and tighten
the six bolts to a torque of 23.7 + 6 1 Nom
(17 + 5 lb ft.)
3-50
