TM 5-3805-260-24
STARTING MOTOR
Disassemble Starting Motor (9G4339)
Tools Needed
A
1 P1855 Retaining Ring Pliers
1
Start By:
a. remove starting motor
1. Disconnect wire assembly (2) from solenoid assembly
(1). Disconnect motor (Mtr) terminal connector (4)
from the starting motor housing.
2. Remove three bolts (3) and solenoid assembly from
the shift lever housing Do not disassemble the
solenoid. The seals inside it are not serviceable
3. Remove the negative (-) terminal nuts, wire assembly
(2) and washers Remove six bolts (6) and rear
housing assembly (5).
4. Remove the bushing from the rear housing if
necessary
5. Remove washer (10) from the armature shaft. Lift
brush springs (8) and pull brushes up off the
commutator Position the brush springs on the side
of the brushes to hold them In their holders
6. Disconnect field winding leads (9) from brush holder
assembly (7) Remove the brush holder assembly
7. Remove brushes (12) and negative (-) terminal (11)
from
the
brush
holders.
3-46