TM 5-3805-260-24
Starting Motor
(1) Solenoid assembly (2) Wire assembly (3) Solenoid bolts (4) Motor (Mtr) terminal connector (5) Rear housing assembly
(6) Rear housing bolts (7) Brush holder assembly (8) Brush springs (9) Field winding leads (10) Washer (11) Negative (-)
terminal (12) Brushes (f3) Pinion drive housing assembly (14) Pinion drive housing bolts (15) Shift lever nut (17) Pinion
drive assembly (19) Shift lever housing assembly (20) Shift lever housing bolts (21) Armature assembly (22) Field winding
(coil) assembly (24) Field winding screws (25) Washer (26) Shift lever assembly (27) Plunger assembly
Assemble Starting Motor
Tools Needed
A
B
1P1855 Retaining Ring Pliers
1
1P510
Driver Group
1
1. Put SAE 20W oil on all bushings, seals and oil wicks.
2. Put field winding (coil) assembly (22) and pole shoes
(23) in position in the starting motor housing. Install
screws (24) and tighten them to a torque of 44 + 20
N-m (32 + 15 lb, ft.).
3. Put armature assembly (21) in position in the starting
motor housing
3-49
