TM 5-3805-260-24OIL FILTER BASE AND ENGINE OIL COOLERDISASSEMBLE OIL FILTER BASE ANDENGINE OIL COOLERstart by:a)remove oil filter base and engine oil cooler1. Remove the bolts that hold cover (I) to base (2).Remove the cover.2. Remove the three nuts that hold core (3) to the base.Remove the core.3. Remove the cap and fitting (6), spring (5), and valve (4)from the base.ASSEMBLE OIL FILTER BASE ANDENGINE OIL COOLER1. Install the valve, spring, fitting (3) and cap in base (2).Tighten fitting (3) to a torque of 19 + 4 Ib.ft. (25 +5 N.m). Tighten the cap to a torque of 15 + 4 lb.ft. (20 + 5 N.m).2. Inspect the gasket that goes between the oil filter base andthe core. Install a new gasket if needed.NOTE: The gasket must be installed with point (4) (indexingpoint) in the position shown.3. Install the core in the base. Install nuts (I). Tighten the nutsto a torque of 16 + 2 lb.ft. (21 +3 N.m).4. Inspect the gasket that goes between the core and cover(6). Install a new gasket if needed.5. Put the cover in position on the base. Install bolts (5).end by:a) install oil filter base and engine oil cooler3-54
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
