TM 5-3805-260-24
ELEVATOR SPEED REDUCER
20.
Turn the housing as shown. Put it in place on
wood blocks and remove shaft (31) with a soft
faced hammer.
21.
Remove bearing cup (32) and shims (33) from
the housing.
22.
Install tooling (B) and remove plate (34). The
two bearings on top of the plate will slide off with
the plate.
23.
Remove Duo-Cone floating seal (35) from the
shaft assembly. Put identification on the seal for
correct installation. Remove the rubber toric sea-
ling ring from the metal floating ring.
24.
Remove Duo-Cone floating seal (36) from the
plate. Put identification on the seal for correct
installation. Remove the rubber toric sealing ring
from the metal floating ring.
25.
Remove bearing cup (37).
4-124
