ASSEMBLE ELEVATOR SPEED REDUCER (cont)

ASSEMBLE ELEVATOR SPEED REDUCER (cont) - TM-5-3805-260-24_744

TM-5-3805-260-24 Scraper Tractor: Elevating Self-Propelled 11 Cubic Yard Sectionalized and Nonsectionalized Manual
Page Navigation
705

TM 5-3805-260-24 ELEVATOR SPEED REDUCER 6. Install bearing cup (6) in housing (7). 7. Put housing (7) on wood blocks. Install shaft assembly (8) in the housing without shims. 8. Tighten the bolts that hold plate (2), while the shaft is turned. When the force to turn the shaft increases, bearings are in position. Loosen all bolts in the plate and then tighten four bolts only, 90 apart, to a torque of 10 to 15 Ib.in. (1.1 to 1.7 N.m). 9. Measure the gap under plate (2) at the four bolt locations with a feeler gauge. 10. Remove the bolts and plate (2). 11. Install a thickness of shims .001 to .005 in. (0.03 to 0. 13 mm) less than the gap measured in Step 8. Install plate (2), the bolts and lockwashers. Tighten the bolts to a torque of 32 5 Ib.ft. (45 7 N.m). NOTE: Put 4H5363 Sealer on threads of bolts. 12. Install plate (12) in gear (13). Install plates (I 1), locks (9) and bolts (10). Bend up lock tabs after the bolts are tightened. 13. Turn the housing as shown. Install gear assembly (13) in the housing. 4-126

Privacy Statement
Press Release
Contact