TM 5-3805-260-24
ELEVATOR SPEED SELECTOR VALVE
REMOVE ELEVATOR SPEED
SELECTOR VALVE
WARNING: Make sure all of the pressure in
the hydraulic system is released before any
lines are disconnected.
1.
Drain the oil from the hydraulic tank.
NOTE: Put identification on all hoses and tubes for
correct assembly.
2.
Disconnect hose (2) from the elbow. Disconnect
hoses (I) from the support angle.
3.
Disconnect tubes (3) from the elevator control
valve.
4.
Remove bolts (4) from the clips and disconnect
hoses (5) at the hitch.
5.
Disconnect electrical connection (6). Disconnect
hose (7) from the support angle. Disconnect
hoses (8) and (9) from the fittings.
6.
Disconnect two hoses from elbow (11) and re-
move nut (10). Remove elbow from the support
angle.
4-130
