TM 5-3805-260-24
ELEVATOR SPEED REDUCER
21.
Fasten a hoist to cage (17). Install the cage in the
housing.
22.
Install two roller bearings (27) on the shaft.
23.
Put ring (28) on wood blocks. Install the seal
with tooling (B). Install the seal until it makes
contact with the counterbore in the housing and
with the lip of the seal toward the inside of the
ring.
24.
Turn ring (28) over. Install gear (29) on the ring.
Install the plates, the locks and bolts (30). Bend
up lock tabs after the bolts are tightened.
25.
Install O-ring seal (32) and bearing (31) as
shown.
26.
Slide bearing (36) on shaft (34). Install snap ring
(35) on the shaft with tool (C). Install O-ring seal
(33) on the shaft in groove below splines.
4-128
