ASSEMBLE ELEVATOR SPEED REDUCER (cont)

ASSEMBLE ELEVATOR SPEED REDUCER (cont) - TM-5-3805-260-24_743

ASSEMBLE ELEVATOR SPEED REDUCER (cont) - TM-5-3805-260-24_745

TM-5-3805-260-24 Scraper Tractor: Elevating Self-Propelled 11 Cubic Yard Sectionalized and Nonsectionalized Manual
Page Navigation
706

TM 5-3805-260-24 ELEVATOR SPEED REDUCER 14. Install lockring (15) on shaft (14). Install bearing (16). 15. Install sleeves (18) and balls (19) in cage (17). Alignment of the hole in the sleeve and the notch in the cage must be correct before ball can be installed in position. Be careful in next step so that balls do not fall out of sleeves. 16. Put cage (17) on its side as shown. Put the bear- ings in gears (20) and install the gears in the cage. Install shafts (2 I) through the cage and the gears. Put balls (22) in the holes at the end of the shafts and install the balls in the notches in the cage. 17. Put the cage in position as shown and be careful so that shafts do not slide out. To adjust bearing, install bolt (23) and washer (26) without shims (25). Tighten bolt until gear does not turn freely. 18. Measure the gap under the washer with a feeler gauge to get the thickness for shims. 19. Remove bolts (23) and washers (26). 20. Install the thickness of shims (25) measured in Step 18 and install washer (26), lock (24) and bolt (23). Tighten the bolt to a torque of 50 + 10 lb.ft. (70 ⁺14 N.m). Do each bolt separately. NOTE: Gear must turn freely with no end play on bearings, .000 to .002 in. (0.00 to 0.05 mm) tight. 4-127

Privacy Statement
Press Release
Contact