INPUT TRANSFER GEARS
Install two 3/8"-16 NC forcing screws in gear (15) and
remove bearing (18).
Remove the ring that holds the bearing cups apart from
cage assembly (14).
Use tooling (A) and remove the inner and outer bearing
cups from cage assembly (14).
ASSEMBLE INPUT TRANSFER GEARS
Heat bearing cone (2) in oil to a maximum temperature of
275°F (135°C) and install the bearing on the output gear
Install the ring that holds the bearing cups apart in cage
Lower the temperature of the inner and outer bearing cups
and install them in cage assembly A36476 (3).