TM 5-3800-205-23-1
TROUBLESHOOTING PROCEDURES - CONTINUED
0007 00
Table 10. Transmission Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. Torque Converter Oil Temperature Alert
Indicator and Action Light Come On
(Indicates Overheating During Normal
Operation) - Continued.
NOTE
Before checking oil level, ensure machine is parked on level ground with parking brake applied, trans-
mission in N (Neutral), oil warm, engine at low idle, ejector moved fully forward, and scraper bowl/
water distributor tank lowered with slight downward pressure applied.
3. Check transmission oil level.
a. If transmission oil is low, fill
to correct level (TM 5-3800-
205-10-1 or TM 5-3800-205-
10-2).
b. If problem still exists, notify
DS Maintenance.
4. Transmission Shifting is Rough.
1. Check control linkage for
a. Adjust control linkage (WP
proper adjustment.
b. If problem still exists, go to
test step 2.
NOTE
Prior to removing major assembly, contact SRA for further troubleshooting information and/or
technical assistance. For SRA support, contact the local Caterpillar dealer (WP 0175 00).
a. Reset modulation relief valve
2. Check primary pressure
primary setting. If problem
setting of modulation relief
still exists, go to step b.
valve.
b. Replace modulation relief
valve.
c. If problem still exists, go to
test step 3.
a. If no movement of load piston
3. Check for movement of
is observed, replace pressure
pressure control valve load
control valve.
piston.
b. If problem still exists, go to
test step 4.
