TM 5-3800-205-23-1
AIR/HYDRAULIC BRAKE CYLINDER REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Materials/Parts - Continued
Maintenance Level
Unit
Tape, antiseizing (Item 40, WP 0171 00)
Tools and Special Tools
Personnel Required
Tool kit, general mechanic's (Item 33, WP 0172
Two
Shop equipment, common no. 1 (Item 24, WP
Equipment Condition
Center and rear guard plates removed (WP 0100
Materials/Parts
Cap set, protective (Item 5, WP 0171 00)
Air tanks drained (TM 5-3800-205-10-1 or TM 5-
3800-205-10-2)
Tag, marker (Item 39, WP 0171 00)
WARNING
Do NOT disconnect any air system lines or fittings unless engine is shut down and air system pressure
is relieved. Failure to follow this warning could result in serious injury to personnel.
Always wear eye protection when disconnecting air lines. Residual air will be expelled. Failure to fol-
low this warning may result in serious eye injury.
CAUTION
Cap all lines, hoses, and tubes to prevent fluid loss and contamination of oil system.
NOTE
Tag all hoses, tubes, and wires to aid in installation.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance,
testing, adjusting and repair of machine. Be prepared to collect fluid with suitable containers before
opening any compartment or disassembling any component containing fluids.
Dispose of all fluids according to local regulations and mandates.
Air/hydraulic brake cylinders are replaced in a similar manner. There are minor differences in the con-
figuration of hoses and fittings. One air/hydraulic brake cylinder is shown.
