TM 5-3800-205-23-1
CYLINDER HEAD REPLACEMENT - CONTINUED
0125 00
REMOVAL - CONTINUED
3.
Remove cylinder head gasket (5) from cylinder block.
5
Discard gasket.
INSTALLATION
1.
Check for warpage on engine block surface.
NOTE
To avoid damage to cylinder head gasket, use guide bolts of an appropriate size to install cylinder head.
2.
Install a new cylinder head gasket (5) on cylinder block.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Cylinder head weighs 187 lb (85 kg).
3.
Attach suitable lifting device to cylinder head (4).
4.
Position cylinder head (4) onto dowels in cylinder block. Lower cylinder head onto cylinder block.
5.
Inspect condition of cylinder head bolts (2 and 3). Replace bolts if damaged.
6.
Lubricate cylinder head bolts (2 and 3) and both sides of washers (1) and install washers and bolts.
0125 00-3
