TM 5-3800-205-23-1
CONTAINER REPAIR - CONTINUED
0164 00
REPAIR OF FACE/SKIN DAMAGE TO FIBERGLASS REINFORCED PLASTICS (FRP)
MATERIAL - CONTINUED
9.
Mix sufficient filler paste and catalyst and apply a
layer approximately 1/16 in. (1.6 mm) thick to all
edges of both opening and patch. Insert patch from
inside. Small screws may be used to secure in posi-
tion.
390-1921
NOTE
On small patch, up to 12 x 12 in. (305 x
305 mm), an additional layer should be
applied over entire repair. For larger
patches, a second layer of glass rein-
forcement should be attached over joint
area only. This layer should be at least 2
in. (51 mm) wider than first application.
Sand area and fill any voids or depres-
sions with filler paste material and allow
to harden.
390-1923
0164 00-18
