TM 5-3800-205-23-2
REAR SERVICE BRAKESHOES AND BRAKE CALIPER REPLACEMENT - CONTINUED
0011 00
BRAKESHOES REMOVAL - CONTINUED
2.
Loosen bolts (5) that secure pins (3) in position.
3.
Install 1/2 in. X 13NC bolts (4) in pins (3).
4.
Use bolts (4) to remove pins (3).
5.
Remove brakeshoes (6) from caliper (2).
CLEANING AND INSPECTION
1.
Clean and inspect all parts.
2.
Measure thickness of brakeshoes at each end. Minimum allowable thickness in area of most wear for a used brakeshoe
is 0.591 in. (15.01 mm).
3.
Replace worn and damaged parts.
BRAKESHOES INSTALLATION
2
1
3,4
1.
Remove bolts (4) from pins (3).
2.
Install brakeshoes (6) in caliper (2).
3.
Push in pins (3) and tighten bolts (5).
4.
Check clearance between pin (3) and brake disc:
a.
Clearance between pin (3) and brake disc must
not be less than 0.010 in. (0.25 mm) and not
more than 0.118 in. (3.00 mm).
b.
If clearance between pin (3) and brake disc is
less than 0.010 in. (0.25 mm), loosen bolt (5) and
slide pin (3) to obtain required clearance.
5.
Tighten two bleeder screws (1).
390-599
5
6.
Bleed service brake system (WP 0015 00).
6
5
7.
Install rear tire and rim (WP 0016 00).
BRAKE CALIPER REMOVAL
1.
Loosen nut (8) and disconnect brake line (7) from
2
7
brake caliper (2). Install protective cap on brake line.
8
0011 00-2
