TM 5-3800-205-23-2
REAR TIRE AND RIM REPLACEMENT - CONTINUED
0016 00
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Tire and rim assembly weigh 928 lb (421 kg).
1.
Position tire (4) on scraper.
2.
Install two washers (2) and nuts (1) on rim (3) and remove lift truck from tire (4).
3.
Install 14 remaining washers (2) and nuts (1) on rim (3). Tighten nuts to 105 lb-ft (140 Nm).
4.
Tighten nuts (1) to 370 lb-ft (500 Nm).
3
1,2
4
5.
Remove two stands and use floor jack to lower scraper to ground.
WARNING
Use of a tire inflation safety cage is required if tire has inflation pressure of 36 psi (248 kPa) or less. Failure
to do so may result in injury or death to personnel.
6.
Check tire pressure and add air as required (TM 5-3800-205-10-1).
END OF WORK PACKAGE
0016 00-4
