TM 5-3800-205-23-2
ELEVATOR MOTOR REPLACEMENT - CONTINUED
0019 00
REMOVAL
1.
Relieve hydraulic system pressure (to facilitate disconnection and connection of hoses) by moving control levers
through all positions (TM 5-3800-205-10-1).
2.
Disconnect hydraulic hose quick-disconnects (1, 5, and 7) from elevator motor (4).
3.
Position nylon sling and suitable lifting device on elevator motor (4).
1
2,3
4
5
7
6
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Elevator motor weighs 65 lb (30 kg).
4.
With assistance, remove two bolts (2), washers (3), and elevator motor (4) from elevator drive speed reducer (6).
0019 00-2
