TM 5-3805-248-23-1
ELECTRICAL ACCESSORIES TROUBLESHOOTING PROCEDURES - CONTINUED
0011 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
f. Observe multimeter while pressing
1. If voltage is present, reconnect purple
2.
Engine Cranks but Fails to
ether starting aid switch.
wire and go to Step g.
Start in Cold Weather
(Ether Starting Aid
2. If no voltage present, go to Test 5.
Inoperative) - Continued.
g. Connect multimeter positive lead to
1. If voltage is present, go to Test 4.
white wire (solenoid side) and
2. If no voltage is present, replace ether
multimeter negative lead to chassis
solenoid valve (WP 0039 00).
ground.
394-1625
4.
Check for continuity to ether start
sender switch.
a. Place battery disconnect switch in
OFF position (TM 5-3805-248-10).
b. Set multimeter to appropriate ohm
(Ω) range.
c. Connect multimeter positive lead to
1. If continuity is indicated, replace ether
white wire at solenoid valve
solenoid valve (WP 0039 00).
(harness side) and multimeter
2. If no continuity is indicated, repair open
negative lead to white wire at ether
circuit white wire (WP 0018 00).
start sender switch (harness side).
0011 00-4
