TM 5-3805-248-23-1
ELECTRICAL ACCESSORIES TROUBLESHOOTING PROCEDURES - CONTINUED
0011 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
c. Place wiper switch in high position.
11. Windshield Wiper Is
Inoperative - Continued.
d. Disconnect wiper motor orange wire
e. Connect multimeter positive lead to
wiper motor orange wire (harness
side) and multimeter negative lead
to chassis ground.
394-1574
f. Place battery disconnect switch in
1. If battery voltage is not indicated, go to
ON position (TM 5-3805-248-10).
Test 6.
2. If battery voltage is indicated, replace
wiper motor assembly (WP 0217 00).
6.
Check high speed circuit for
continuity.
a. Place battery disconnect switch in
OFF position (TM 5-3805-248-10).
b. Set multimeter to appropriate ohm
(Ω) range (WP 0018 00).
c. Disconnect wiper motor switch
electrical connections (WP 0063
d. Connect multimeter positive lead to
1. If continuity is not indicated, repair
wiper motor orange wire (harness
open circuit between wiper motor and
side) and multimeter negative lead
wiper switch (WP 0018 00).
to wiper motor switch orange wire
2. If continuity is indicated, replace wiper
(harness side).
switch (WP 0063 00).
0011 00-32
