TM 5-3805-248-23-1
HOSES (WITH CROSSOVER TUBE), LINES AND FITTINGS TO BOWL
CYLINDERS REPLACEMENT - CONTINUED
0238 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
1.
Remove all preformed packing material from mounting surfaces.
2.
Clean all parts with solvent.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
INSTALLATION
NOTE
Lightly coat all new preformed packings with clean oil prior to installation.
1.
With assistance, push bowl cylinder toward rear of machine and install tube assembly (15).
2.
Install four washers (24) and bolts (23) on tube assembly (15).
15
23,24
394-556
BOWL LIFT CYLINDER
0238 00-4
