TM 5-3805-248-23-2
LOWER REAR EJECTOR ROLLER REPLACEMENT - CONTINUED
0329 00
REMOVAL
WARNING
Ensure machine will not roll or shift before jacking it or placing it on jack stands. Use chock blocks to pre-
vent machine from rolling. Death or injury may result if you fail to follow this procedure due to vehicle turn-
ing or slipping off jacks or jack stands.
NOTE
The following procedure is for the lower-right, rear ejector roller. The procedure for the lower-left, rear ejec-
tor roller is identical.
1.
Position lifting device firmly under ejector bracket on
3
4
2
lower-rear, right side of ejector.
1
2.
Using lifting device, raise ejector bracket (5) until
roller (4) turns freely. Raising ejector bracket too high
will bind roller in guide track.
3.
Remove fitting (1), four bolts (2) and washers (3).
5
394-1449
4.
Install two forcing screws in shaft (6). Tighten evenly
3/8-16NC FORCING SCREWS
until shaft is loose.
5.
Remove two forcing screws from shaft (6).
6
394-1450
0329 00-2
