TM 5-3805-248-23-2
LOWER REAR EJECTOR ROLLER REPLACEMENT - CONTINUED
0329 00
REMOVAL - CONTINUED
6.
Remove shaft (6) and shim(s) (7).
8
7
6
7.
Remove roller assembly (8) from guide track.
3/8-16NC
FORCING
SCREWS
5
GUIDE TRACK
394-1451
8.
Remove and discard seal (9) from roller (8).
9
9.
Use hammer and punch to remove bearing (10) and
10
roller (8).
8
394-1452
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may cause
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Clean all parts with solvent cleaning compound.
2.
Dry all parts with compressed air.
3.
Inspect all parts for damage and replace as necessary.
0329 00-3
