TM 5-3805-248-23-2
LOWER FRONT EJECTOR ROLLER MAINTENANCE - CONTINUED
0330 00
ASSEMBLY
1.
Use grease to lubricate bearing (14).
16
17
2.
Use driver and hammer to install bearing (16) in roller
(5). Tap driver gently until bearing is firmly against
roller counterbore.
5
3.
Use driver and hammer to install bearing (17) in roller
5
assembly (5).
394-1458
4.
Use grease to lubricate bearing (15).
6
5.
Install bearing (15) in roller assembly (5).
13
6.
Use grease to lubricate lip of seal (14).
7
8
14
9
15
10
11
5
12
5
394-1456
NOTE
When installing seal, lip of seal must face inside of roller.
7.
Use driver and hammer to install seal. Tap gently until seal (14) is seated firmly against bottom of roller assembly coun-
terbore.
8.
Install shaft (13).
9.
Use grease to lubricate inside of roller (5).
10.
Use grease to lubricate and install bearing (12) on roller assembly (5).
11.
Install washer (11), lock (10) and nut (9). Tighten nut (9) until roller (5) will not turn by hand. Then loosen nut 1/16 of
one turn.
12.
Install new gasket (8), cover (7) and four bolts (6).
0330 00-4
