TM 5-3805-248-23-2
GOVERNOR ASSEMBLY REPAIR - CONTINUED
0354 00
FUEL SETTING PROCEDURE - CONTINUED
NOTE
If you are working from the side of the engine and cannot see the adjusting screws, use the outer edge of the
opening in the governor housing to guide the tool onto the fuel setting screw. Use the inner edge of the open-
ing to guide the tool onto the full torque setting adjustment screw.
102
104
103
103
394-1717
394-1716
21.
If both settings are to be increased, turn torque rise adjustment screw (104) out (counterclockwise) same number of turns
as fuel setting adjustment screw (102) will be changed. If static fuel setting is to be decreased, it is not necessary to
change full torque setting at this time.
22.
Use rack adjustment tool (103) to loosen locknuts for adjustment screws (104) and to turn adjustment screws.
23.
Adjust fuel setting adjustment screw (102) the number of turns determined in step 21. Always recheck setting after each
adjustment and adjust again if needed.
NOTE
There is a zero tolerance for the fuel setting and full torque setting when an adjustment is made.
24.
After static fuel setting is correct, adjust torque rise adjustment screw (104) the number of turns determined in step 21.
25.
Always recheck setting after each adjustment and adjust again if needed.
26.
Install injection pump housing and governor assembly (WP 0273 00).
27.
Install fuel transfer pump (WP 0275 00).
28.
Install air-fuel ratio control (WP 0355 00).
29.
Operate machine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0354 00-20
