TM 5-3805-260-24
INPUT TRANSFER GEARS
12.
Install gear (6) in the case assembly. Make sure the teeth of
gear (6) and the output gear are engaged.
13.
Install the spacer on gear (6).
14.
Install the ring that holds the bearing cups apart in cage (9).
15.
Lower the temperature of the inner and outer bearing cups
(8). Install the bearing cups in cage (9).
16.
Install the O-ring seal on cage (9) and install cage (9) in the
case assembly.
17.
Heat the outer bearing cone in oil to a maximum temperature
of 275°F (I 35°C).
Install the bearing cone on input gear
(6).
18.
Use a press and a 2 3/4" x 3/4' drive socket to install seal
(10) in the case assembly with the seal case even with the
case assembly and the seal lip toward the inside as shown.
19.
Install flange (12), the washer and bolt (I 1). Tighten the bolt
to a torque of 80 - 5 lb.ft.
(I 10 + 7 N.m).
end by:
a) connection of input transfer gears to transmission
3-194
