TM 5-3805-260-24
TRANSMISSION
49.
Install tool (B) to hold No. 3 clutch piston (58) and the No. 4
clutch piston in position.
50.
Install two 1/2’"-13 NC forged eyebolts in clutch housing (55).
Fasten a hoist and remove clutch housing (55) the pistons
and the two planetary gear assemblies as a unit. Weight of
the unit is 90 lb. (41 kg).
51.
Remove tool (B) and remove the pistons from clutch housing
(55).
52.
Remove the seal rings from the pistons.
53.
Remove bolt (59), the plate and the No. 3 carrier from clutch
housing (55).
54.
Turn clutch housing (55) over. Remove ring (63) that holds
carrier (60) in position and remove No. 2 carrier (60) from
the clutch housing.
55.
Remove ring (61) and bearing (62) from clutch housing (55).
56.
Remove seal rings (64) from each side of the clutch housing.
57.
Remove the pins and the ring from the groove in No. 2
carrier (60).
58.
Push pins (66) into shafts (65) with a punch and hammer.
59.
Remove shafts (65), gears (67) and the washers from carrier
(60). There is a washer on each side of the gears. Remove
the bearings from the gears. Remove the pins from the
shafts.
3-200
