TM 5-3805-260-24
TRANSMISSION
60. Remove seal ring (68) from No. 3 carrier (71).
61. Push pins (70) into shafts (69) with a punch and
hammer.
62. Remove shafts (69), gears (72) and the washers from
carrier (71). There is a washer on each side of the
gears. Remove the bearings from the gears. Remove
the pins from the shafts.
63. Remove springs (73) and pins (74).
64. Remove No. 4 disc assemblies (75) and the plates.
65. Remove ring (76) and remove gear (77).
66. Install tool (B) to hold No. 5 piston (79) in No. 5 clutch
housing (78).
67. Install two 7/16"-14 NC forged eyebolts in clutch
housing (78). Remove the clutch housing and piston
(79) by hand.
68. Remove tool (B) and piston (79) from the clutch
housing. Remove the seal rings from the piston and
clutch housing.
3-201
