TM 5-3805-260-24
TRANSMISSION
9. Install pins (14) and springs (13) in the No. 6 clutch housing
assembly.
10. Assemble No. 6 planetary carrier (15) as follows:
a) Install bearing (16) in each gear (17).
b) Put gears (17) in position in carrier (15) with
washers (20) on each side of the gears.
c) Install shafts (I 8) in carrier ( 15) to hold gears
(17) and the washers. Make sure the holes in
the shafts are in alignment with the holes in the
carrier.
d) Install pins (19) even with the surface of carrier
(15) to hold shafts (18) in position.
11. Put No. 6 planet carrier (15) in position on the clutch
housing. Make sure the springs and pins are in position
and install the washers and bolts (24). Tighten the bolts to
a torque of 85 5 Ib.ft. (115 7 N m).
12. Install sleeve (23), sun gear (22), the washer and bolt (21).
Tighten the bolt to a torque of 34 2 Ib.ft. (45 3 N m).
13. Install plate (26) and No. 5 clutch ring gear (25).
14. Install long pins (28), the two disc assemblies (27) and plate
(29). There must be a disc assembly on each side of plate
(29).
3-205
