TM 5-3805-260-24
TRANSMISSION
21. Assemble No. 4 planetary carrier as follows:
a) Install seal rings (38) on carrier (45).
b) Install bearings (39) and (41) in each gear (40).
c) Put gears (40) in position in carrier (45) with
washers (44) on each side of the gears.
d) Install each shaft (42) in carrier (45) to hold
gears (40) and washers (44) in position. Make
sure the holes in the shafts are in alignment
with the holes in the carrier.
e) Install pins (43) even with the surface of carrier (45)
to hold shafts (42) in position.
22. Assemble No. 3 planetary carrier as follows:
a) Install seal ring (46) on carrier (47).
b) Install bearings (48) and (50) in each gear (49).
c) Put gears (49) in position in carrier (47) with
washers (53) on each side of the gears.
d) Install each shaft (51) in carrier (47) to hold
gears (49) and washers (53) in position. Make
sure the holes in the shafts are in alignment
with the holes in the carrier.
e) Install pins (52) even with the surface of carrier
(47) to hold shafts (51) in position.
23. Lower the temperature of bearing (54). Install the bearing
in No. 3 and 4 clutch housing (55) with the notch of the
bearing down toward the No. 3 clutch side of housing
(55).
24. Install ring (56) to hold bearing (54) in position.
25. Install No. 3 planetary carrier (47) in the No. 3 and 4
clutch housing. Make sure dowel (57) in the carrier is in
alignment with notch (58) in the bearing.
3-207
